The increasing use of natural materials in German offshore wind

Material selection is playing an increasingly important role in offshore cable projects. In addition to mechanical performance, installation and long-term reliability, greater attention is also being paid to the materials that are placed on or in the seabed.

In Germany, this is clearly reflected in the regulations for designated offshore wind areas in the German Exclusive Economic Zone (EEZ).

Since 22 December 2020, the first Windenergie-auf-See-Verordnung has stipulated that cable protection should in principle use natural stone or other inert and natural materials. Cable Protection Systems containing plastic are only permitted in exceptional cases and their use must be reduced to a minimum. The same wording can also be found in later German offshore wind regulations.

This is explicitly not a general ban on plastic in every offshore application. It does, however, mean that the use of plastic in cable accessories must increasingly be justified and reduced as much as possible.

Why is this relevant for cable accessories

As offshore wind uses a lot of inter array cables and the  power networks continue to expand, new export cables, interconnectors, joint boxes and other subsea cables accessories increasingly need to cross existing cables or pipelines.

At such crossings, sufficient separation between both assets must be created, while the cable also needs to be mechanically protected and supported in a controlled manner.

Traditionally, solutions such as concrete mattresses have been used to provide protection and separation at cable crossings. However, these systems often incorporate synthetic ropes to secure the concrete blocks together. Over time, these ropes can deteriorate which can cause challenges especially in recovery operations. Consequently, for projects located in areas where the use of plastic-containing cable protection is restricted, the selection of suitable crossing systems becomes increasingly important, both from an environmental and long-term operational perspective.

TurnCross: a new approach to cable crossings

TurnCross can be installed directly onto the new cable and creates a defined and controlled crossing arrangement. The system was developed with the aim of simplifying the offshore installation process. This year, an offshore trial of the system in the North Sea was successfully completed.

The Cable Crossing System is part of the Vos Prodect product portfolio.

The Vos Prodect solution

At Vos Prodect we believe in natural materials such as steel, cast iron and rock. We try to limit the use of plastic as much as possible.

So we see that our Cable Protection Systems, our Joint Bend Restrictors and the cable crossing system are gaining momentum.

TurnCross will make the difference as it is easier to install and saves one working cycle with a mattress laying vessel.

Designing around changing offshore requirements

German regulations do not mean that plastic-containing Cable Protection Systems are completely prohibited. However, they do clearly state that their use within the relevant offshore wind areas is only permitted in exceptional cases and must be reduced to a minimum.

Because Vos Prodect  supports all sort of offshore projects around the globe they are used to specific regulations and  projects to support  with align solutions with project-specific/ environmental requirements.

With extensive experience supporting offshore projects worldwide, Vos Prodect has developed a strong understanding of diverse regulatory frameworks and project-specific requirements. Through our expertise in engineering, design, testing and project development, we deliver tailored solutions that align with the technical, regulatory and environmental requirements of each project.

Would you like to discuss how TurnCross or another solution could be applied within a future offshore cable project? Contact Vos Prodect.